ECOSURE EAF 68:
The Environmentally Acceptable Hydraulic Fluid delivering superior fluid life and oxidation resistance
- Exceeds requirements of ISO 15380
- Extended fluid life
- Good extreme temperature performance
- ISO 22, 32, 46, 68 & 100 available
For water tight doors, ramps, platforms, davits, cranes, winches and capstans
|ECOSURE EAF 68 – AT A GLANCE|
|Pump lubrication||Eaton 104C & 35VQ||Pass|
|Parker Hannifin Denison T6H20C||Pass|
|Wear Protection||FZG||> Load Stage 12|
|Corrosion Protection||ASTM D-130 Copper Corrosion||Pass|
|ASTM D-665 Rust (Fresh & Sea Water)||Pass|
|Elastomer Compatibility||Nitrile, Viton, Teflon, Nylon, PTFE||Pass|
|Demulsification||ASTM D1401 (Fresh & Sea water)||Pass|
The EU Ecolabel is a label of environmental excellence that is awarded to products and services meeting high environmental standards throughout their life cycle: from raw material extraction, to production, distribution and disposal.
EU Ecolabel licence number UK/027/017 has been awarded to the ECOSURE EAF range.
These Ecolabel hydraulic fluids, based on synthetic esters, are typically used in water tight doors, ramps, platforms, davits, cranes, winches and capstans where there is potential for fluid loss to occur to the marine environment.
ECOSURE EAF has been strongly recommended by several OEMs for its superior performance properties in critical applications below the waterline and meets the environmental requirements of Swedish Standard 15 54 34.
ECOSURE EAF 68 achieves over 330 minutes in the ASTM D-2272 RPVOT oxidation test, demonstrating greater performance and longer fluid life than many competing mineral and biodegradable hydraulic fluids. ECOSURE EAF exhibits excellent low temperature performance with a pour point of < -48°C, making it particularly suitable for use in deck equipment exposed to very cold climates.
ECOSURE EAF achieves biodegradability of greater than 60% in the 28 day OECD 301B test, and is considered non-toxic in the marine environment based on the following results:
|LC50 exceeds 1000 mg/l||EC50 exceeds 1000 mg/l||EC50 exceeds 1000 mg/l|
ECOSURE EAF meets the detailed ecological definitions and requirements laid down in the 2013 Vessel General Permit (VGP) published by the US EPA in March 2013.
|Extended fluid life||Fewer fluid changes, less equipment downtime and lower overall cost of ownership|
|Improved lubricity||Less wear and longer pump life|
|Wider operating temperatures||Protects equipment from -35°C to over +100°C|
|Good hydrolytic stability||Resists breakdown of the lubricant by water in high temperature situations|
|Good oxidative stability||Less sludge and system failures, longer fluid life and less fluid thickening|
|Good thermal stability||Less fluid thickening and system failures due to lower levels of corrosive decomposition products|
|Superior demulsification||Excellent water separation allowing easy removal of water and reduced pump wear|
|Good VI||Fluid remains within the desired viscosity over a broader temperature range|
|Good shear stability||Less viscosity loss, fewer fluid changes and prolonged pump life|
|Good seal compatibility||Less leakage and less equipment downtime|
|Good long term filterability||Less filter blockage and less equipment downtime|
|Biodegradable and minimally toxic||Lower environmental risk|